Emtech-electronics BLU-SV8T Instrukcja Użytkownika Pobierz pdf (Strona 1)

BLU-SV8T Source Selector/Volume Control

BLU-SV8 Wiring Instructions

IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be

crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.

You must crimp and test the wiring with an approved CAT5 568A/B

tester before connecting any cable between the BLU-SV8 and either a

BLU-CIF or BLU-CIF2 Interface unit. Failure to crimp wiring to the

correct standard could possibly lead to component damage.

EIA/TIA568B

1. White-Orange 5. White-Blue

2. Orange 6. Green

3. White-Green 7. White-Brown

4. Blue 8. Brown

The BLU-SV8T is a

source selector/volume

control for BSS Audio

London Series Digital

Signal Processors. It is

built on a dual gang

panel for mounting in a

dual gang electrical box.

The front side of the

control has 8 lighted

momentary pushbutton

switches for selecting

audio, and a pot for

adjusting the volume of

the audio signal. On the backside of the control is a single RJ-45 Cat5e

jack for connecting the BLU-SV8 to the DSP via the BLU-CIF or BLU-

CIF2 SV

orts. The BLU-SV8T installs in the tech room.

1 2

BLU-SV8T Source Selector/Volume Control BLU-SV8 Wiring Instructions IMPORTANT: CAT5e wiring for the RJ

Note: To complete the BLU-SV8 set-up, a change needs to be made inside the BSS Lo

Brak uwag

Emtech-electronics BLU-SV8T Instrukcja Użytkownika Strona 1